LS 100

Miniature & Subminiature

LS 100 Series - Bulletin 103

>	Standard ranges to 40 revolutions.	>	Meet the applicable environmental and materials sections of MIL-E-5400
>	Stop rotation is continuously adjustable throughout the full range.	>	Corrosion resistant steel and anodized aluminum construction.
>	Range is set by means of a single screw at the end of the unit.	>	Precision ball bearings.
>	Flange mounted.

The LS 100 Series Limit Stops feature
extremely simple range setting, low
inertia, low starting friction, and large
turns capacity.

They eliminate the time, cost, and engineering effort required to design, develop and procure limit stops for each new application.

They enable the designer to consider the limit stop as a component and to design with it in the same manner as with potentiometers, motors, and other
standard synchro mounted units.

They provide means for changing the full scale stop range to accommodate tolerance variations which occur in normal fabrication and assembly operations.

The large number of turns available allows the stop to be placed at the low torque, high speed, portion of a gear train thereby freeing the low speed gears from large stopping loads.

The simplicity of adjustment and the large number of available turns enables the stop range to be set with extreme precision.

Part No.	Range Revs	Inertia (oz. in. sec²⁾	Weight (oz.)	Torque Rating Oz. In.	A	D	G	I	P +.0000 -.0008
LS101	0-10	3.9 x 10^-6	1.2	80	.062	.875	.078	1-5/32	.7500
LS102	0-40	7.2 x 10^-6	1.7	80	.062	.875	.078	1-7/8	.7500
LS104D	0-20	1.7 x 10^-6	.75	30	.050	.625	.062	1-15/64	.3125

Stops may be ordered permanently preset to any rotation within their range. Designs with increased ranges and special shafts are available. See bulletin 104 for units with limit switches.

^ top

products page

home page